Delta Tau PMAC2 User Manual download pdf (Page 15)

Turbo PMAC2 Realtime Express Controller

Hardware Setup

Fieldbus Setup Connector, J3

This connector is a 10-pin female flat cable connector that is directly connected to the Fieldbus

communication device installed in the system based on order options. Use SyCon program to set

up the communication module. SyCon is a universal Fieldbus configuration tool developed by

Hilscher Corporation used to configure the PMAC Gateway. Delta Tau has licensed SyConas part

of the PMAC Gateway product. The Hilscher license agreement, which will be presented during

the installation process, still applies.

Besides being able to configure Fieldbus systems like ProfiBus, DeviceNet, CANopen, and

ControlNET, SyCon can also configure Interbus, SDS, etc. The usefulness is that SyCon becomes

a common tool providing consistent user interface for all protocols for both masters and slaves.

SyCon checks the dependencies between the devices, checks for configuration conflicts and

warns of possible errors. Some protocols support standardized files containing information about

all features and limitations of the slave device. SyCon uses these files for the configuration.

After the configuration, switch SyCon into a diagnostic mode. In diagnostic mode, you can

monitor status information of all devices connected to the network. For example, the node list or

slave diagnostic information can be monitored. If a slave is not operating correctly, it will be

displayed in a different color, normally red. The base address for master modules is located at

memory location $6D000 and for slave modules at $6D700.

10- pin Male Flat ribbon header

connector (IDC)

Pin #

Symbol

Function

N.A.

N.C.

HilDTR

Data terminal ready (DTR)

HilTxD-

Transmit Data (TXD)

HilCTS

Clear to Send (CTS)

HilRxD-

Receive Data (RXD)

HilRTS

Request to Send (RTS)

HilDSR

Data Set Ready (DSR)

N.A.

N.C.

GND

Signal Ground

+5V

+5 VDC output

Fieldbus Connection, J4 (Fieldbus option required)

This Female DB-9 connector is connected to the Fieldbus module inside the board and the

communication to the network will be conducted through this port. This will have different pin

out descriptions based on the module installed in the controller.

Profibus

DB9 Female

12345

6789

Pin #

Symbol

Function

N.C.

+5VDC

Positive Power Supply

RXD/TXD-P RS 485

Receive / Send Data –P

CNTR-P

Control Counter TTL

DGND*

Reference Ground *

+5VDC

Positive Power Supply

N.C.

RXD/TXD-N RS 485

Receive / Send Data -N

N.C.

* E8 jumper should be in 1-2 position

1 ... 14 15 16 ... 53

Comments to this Manuals

No comments

Delta Tau PMAC2 User Manual Page 15

Comments to this Manuals

Related products and manuals for Networking Delta Tau PMAC2